2014–2019 Toyota Corolla
Save $220 by doing it yourself! Shop cost: $275
Click links to purchase (we earn from qualifying purchases)
| Part Name | Part Number | Price | Buy |
|---|---|---|---|
| Vehicle-specific engine coolant/antifreeze | — | $55.00 |
About prices: shown prices are estimates from typical Amazon listings and change frequently, and cheaper alternatives may be available. Confirm the current price on Amazon before buying.
💡 Pro tip: Order all parts at once to save on shipping
Follow these steps carefully
Verify the correct coolant type, mixture, capacity, and bleed procedure for the 2014-2019 Toyota Corolla engine. Park level, set the brake, switch the ignition off, let the system cool completely, and remove any underbody shield that blocks the drain area.
Place a large pan under the 2014-2019 Toyota Corolla radiator drain or lower hose. Remove the cap only after the system is cold, open the drain carefully, and collect all coolant; if the design requires it, drain the engine block or follow the manufacturer drain procedure.
Inspect the 2014-2019 Toyota Corolla drain plug, hose ends, radiator, reservoir, thermostat housing, and clamps for cracks or leaks. Refit the drain plug or hose with its seal in good condition and do not overtighten plastic fittings.
If the 2014-2019 Toyota Corolla service procedure calls for a water flush, close the drain, fill with the specified water, run the engine only long enough to circulate with the heater on, cool completely, and drain again. Do not use chemical flush products unless the manufacturer permits them.
Fill the 2014-2019 Toyota Corolla through the radiator, expansion tank, or designated fill point using the correct premix or accurately mixed concentrate. Use a spill-free funnel or vacuum fill tool and stop at the specified cold level.
Follow the 2014-2019 Toyota Corolla engine-specific bleed points and procedure. Set the heater as instructed, monitor the level while the thermostat opens, and never lean over an open filler neck while the engine is hot or pressurized.
After the 2014-2019 Toyota Corolla cools fully, recheck the reservoir or radiator level, inspect all drain and hose connections, and top up only with the matching coolant. Confirm normal cabin heat and temperature-gauge behavior during a short test drive, then recheck for leaks.
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
2003–2008
1998–2002
1998–2002
1998–2002
2003–2008
2003–2008