← Back to Toyota Corolla Guides

2020–2024 Toyota Corolla

2020-2024 Toyota Corolla — Engine Oil & Filter Change

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧 Moderate 30-60 minutes $57 DIY

Save $63 by doing it yourself! Shop cost: $120

Quick answer: Engine Oil & Filter Change on a 2020–2024 Toyota Corolla is rated Moderate and takes about 30-60 minutes. You'll need 3 tools for this job, and parts cost about $57. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$57.00
Oil spec 1.8L 4-cyl hybrid (2ZR-FXE)
Capacity 4.4 qt with filter Viscosity 0W-20
Part Name Part Number Price Buy
Engine Oil (0W-20) — $45.00
Correct engine oil filter and drain-plug washer for 2020-2024 Toyota Corolla Hybrid — $12.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm oil specification and make the vehicle safe

The 2ZR-FXE 1.8L takes 4.4 US quarts of 0W-20; filter is Toyota 04152-YZZA6 cartridge. Open the housing's small drain plug first so it empties cleanly without spilling. Park level, brake set, wheels chocked. Don't reuse the old O-rings.

2

Warm briefly and protect the work area

Warm the engine 2-3 minutes. Gather a drain pan, funnel, cartridge cap wrench, gloves, and the new 04152-YZZA6 element. Raise the front on ramps or jack stands; keep the key away while under the car — it can cycle on.

3

Drain the used oil and replace the filter

Remove the drain plug. Open the housing's drain plug first, then the cap. Fit the new 04152-YZZA6 element with fresh O-rings, confirming the old O-ring isn't stuck in the bore. Torque the cap by feel — plastic strips if forced.

🔧 Mechanic's note — Tom Becker

I've been burned by the 2ZR cartridge housing more than once — open that little housing drain plug first, or you'll wear a quart of oil down your sleeve. I learned the hard way and still remember the stained shirt.

4

Install the correct oil quantity

Reinstall the drain plug with a fresh seal. Pour in 4.4 quarts of 0W-20 through a funnel, adding the last quart slowly. Replace the oil cap. Measure, don't estimate. Wipe the dipstick fully before the final read.

🔧 Mechanic's note — Ray Delgado

I've found the 2ZR dipstick reads cleanest if I wipe it, seat it twice, and read the second pull — the first one almost always smears on these cars.

5

Check level, leaks, and service reminder

Press power to READY and check the housing and plug for leaks. Shut down, wait a few minutes, and confirm the dipstick reads full. Reset the maintenance reminder via the steering-wheel buttons; recycle the used oil and cartridge.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Using the wrong viscosity, capacity, or filter
  • • Working under a vehicle supported only by a jack
  • • Reusing a crushed drain-plug washer or leaving the old filter gasket stuck
  • • Over-tightening the filter or drain plug
  • • Starting the engine before checking the oil level and leaks