← Back to BMW 4 Series Guides

2014–2020 BMW 4 Series

2014-2020 BMW 4 Series — Brake Pad Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧🔧 Advanced 1-3 hours $205 DIY

Save $245 by doing it yourself! Shop cost: $450

Quick answer: Brake Pad Replacement on a 2014–2020 BMW 4 Series is rated Advanced and takes about 1-3 hours. You'll need 4 tools for this job, and parts cost about $205. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$205.00
Part Name Part Number Price Buy
Front or rear brake pad set for 2014-2020 BMW 4 Series; verify axle, brake package, and VIN fitment — $180.00
Replacement pad hardware or wear sensor only if the kit requires it — $25.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm axle, parts, and brake condition

Floating type only: standard single-piston calipers; M Sport's four-piston blue calipers differ. Confirm the front axle; buy pads for your build, plus a wear sensor if the dash warning lit. Measure the rotor against the minimum stamped on the hat.

2

Lift and secure the vehicle

17mm lug bolts — break them loose on the ground. Lift at the factory points onto rated stands — never the jack alone. Chock the rear, remove the wheel. Trace the front-left wear sensor wire to its bracket clip first.

3

Remove the caliper and old pads

Unplug the wear sensor — connector, not wires. Back out the guide pins with a 7mm hex. Slide the caliper off; hang it from the strut. Pull the pads and pins; inspect them and the boot and hose.

🔧 Mechanic's note — Tom Becker

I pull that wear-sensor connector, never the wires — it's fragile, and a broken wire means a dash warning I can't clear. A gentle tug on the connector body does it every time for me.

4

Install pads and hardware

Fit new pads. Seat the wear sensor in the new pad — no pliers — and route the wire through its clip. Push the piston back, watching the reservoir. Grease the pins, refit with caps, clip the anti-rattle spring back.

🔧 Mechanic's note — Tom Becker

No pliers on the wear sensor — seat it with your fingers. I've seen guys crack the sensor body squeezing it in.

5

Torque, pump, and bed in

Torque the hardware to spec. Refit the wheel, hand-threading the bolts, torque in a star pattern. Pump the pedal until firm. Bed the pads with moderate stops from 40 mph, cooling between; confirm no dash brake warning.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Changing only one pad or mixing pad sets on an axle
  • • Working under a vehicle supported only by a jack
  • • Letting the caliper hang from the brake hose
  • • Forcing a seized piston or ignoring a leaking caliper
  • • Skipping final lug and caliper torque or the bedding procedure