EZCarFix DIY Auto Repair
← Back to BMW 7 Series Guides

2016–2022 BMW 7 Series

2016-2022 BMW 7 Series - Engine Air Filter Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Nov 6, 2026

🔧 Easy 10-20 minutes $20 DIY

Save $70 by doing it yourself! Shop cost: $90

Quick answer: Engine Air Filter Replacement on a 2016–2022 BMW 7 Series is rated Easy and takes about 10-20 minutes. You'll need 2 tools for this job, and parts cost about $20. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$20.00
Part Name Part Number Price Buy
Engine air filters (pair) — $20.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Prep and locate the air box

Park on level ground, brake set, ignition off. Pop the hood and find the two boxes — one per bank, either side of the bay. Let a hot engine cool first. No tools needed — both boxes are clip-held.

2

Open the air filter housing

The G11 airbox lid is secured by Torx screws around its perimeter. Back them out with a T20/T25 driver — park loose screws in a magnetic tray, because a dropped screw is effectively gone in the deep engine bay. Ease the lid straight up; if it resists, check for a missed screw rather than prying, since the sealing flange cracks easily.

3

Remove the old filter and clean

Lift both old filters out of the boxes. Wipe out leaves, grit, and oil film; check the drain holes. Keep every speck of debris away from the intake opening downstream of the filter. Compare old and new for identical size and pleat count. Don't leave one side on the old filter.

4

Install the new filter

Drop in the new panel filter — a WIX WA10889, Mann C 28 037, or any equivalent spec'd for the G11 740i — with its rubber sealing edge fully seated in the groove molded into the lower box, matching the old filter's orientation exactly. Press around the entire perimeter with your fingertips to confirm the seal sits flat with no gaps, folded pleats, or lifted corners.

5

Reseal and verify

Confirm every clip on both lids is shut — a loose lid lets unfiltered air into the engine. Close the hood, start the engine, and idle a minute listening for intake whistles. BMW's interval: roughly every 30,000 miles.

🔧 Mechanic's note — Ray Delgado

From my bay, Idle it a minute and listen for intake whistles before you call it done — a whistle is always an unseated lid on these dual-box setups.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Installing the filter upside down or unseated so unfiltered air bypasses the element
  • • Leaving debris in the housing that then gets sucked into the intake
  • • Forcing clips/screws and cracking the plastic air box lid
  • • Reusing a heavily clogged filter instead of replacing it