EZCarFix DIY Auto Repair
← Back to Buick Century Guides

1997–2005 Buick Century

1997-2005 Buick Century — Brake Pad Replacement

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧🔧 Advanced 1-3 hours $205 DIY

Save $245 by doing it yourself! Shop cost: $450

Quick answer: Brake Pad Replacement on a 1997–2005 Buick Century is rated Advanced and takes about 1-3 hours. You'll need 3 tools for this job, and parts cost about $205. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$205.00
Part Name Part Number Price Buy
Front or rear brake pad set for 1997-2005 Buick Century; verify axle, brake package, and VIN fitment — $180.00
Replacement pad hardware or wear sensor only if the kit requires it — $25.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm axle, parts, and brake condition

FRONT axle only, 1997–2005 Century (W-body): single-piston sliding caliper, pads on stainless abutment clips (front pin kits: D699/D818). Confirm front pads — rears differ. Measure friction material; check rotors for deep grooves and compare thickness to the minimum stamped on the hat.

2

Lift and secure the vehicle

Park level, brake set (holds the rears — front job unaffected), chock rear wheels. Break lugs loose on the ground, jack the front corner onto a rated stand under the subframe — never the jack alone. Remove lugs and wheel.

3

Remove the caliper and old pads

Remove the two guide-pin bolts; hang the caliper on a hook — never by the hose. Pull the pads and clips. Check guide pins for rust and free movement; inspect the piston boot and flex hose for leaks or cracking.

🔧 Mechanic's note — Ray Delgado

One pad to metal and the other looking fine is the seized-guide-pin signature — I've seen it a hundred times on W-bodies. If a pin drags, clean it to a shine and regrease; a new pin kit is cheap against another set of pads.

4

Install pads and hardware

Scrape bracket lands to bare metal; high-temp grease under the new clips only. Clean and grease the guide pins; replace torn boots. Open the reservoir; press the piston back with a C-clamp and old pad — don't spill fluid on paint.

5

Torque, pump, and bed in

Refit the caliper; torque guide-pin bolts to the service-data value. Wheel on; on the ground, torque lugs star-pattern to 100 ft-lbs (140 N-m). Pump the pedal firm; recheck the reservoir. Bed with moderate 35–40 mph stops; no hard stops for 150–200 miles.

🔧 Mechanic's note — Ray Delgado

Bedding isn't optional folklore — I've felt brand-new pads shudder because someone did panic stops on the way home. Moderate stops, cool-down between them, and no hard stops for 200 miles gives you a quiet pedal.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Changing only one pad or mixing pad sets on an axle
  • • Working under a vehicle supported only by a jack
  • • Letting the caliper hang from the brake hose
  • • Forcing a seized piston or ignoring a leaking caliper
  • • Skipping final lug and caliper torque or the bedding procedure