← Back to Buick Century Guides

1997–2005 Buick Century

1997-2005 Buick Century — Engine Air Filter Replacement

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 15-25 minutes $35 DIY

Save $75 by doing it yourself! Shop cost: $110

Quick answer: Engine Air Filter Replacement on a 1997–2005 Buick Century is rated Easy and takes about 15-25 minutes. You'll need 1 tool for this job, and parts cost about $35. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$35.00
Part Name Part Number Price Buy
Engine air filter for 1997-2005 Buick Century; verify engine, housing shape, and VIN fitment — $35.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Find the airbox behind the left headlight

Pop the hood on your 1997–2005 Century and look behind the driver's-side headlight — that's where GM tucked the airbox on these W-body cars, ahead of the 3.1L V6. Wipe the dirt off the box before opening it.

2

Flip open the lid's spring clips

If a clip is rusted stiff, work it gently rather than forcing it; a snapped clip means a lid that won't stay shut, and replacements mean a trip to the parts store.

3

Loosen the outlet duct clamp

You don't need to remove the clamp or the duct, back it off so the lid and upper half have room to lift without dragging the ducting.

4

Lift the lid and pull the old filter

Pull the old element out and look at the pleats: on Centuries that run country roads, this box loads up with dust and even field debris, which is why the 3.1L can start feeling flat on acceleration.

5

Clean the lower housing

Vacuum or wipe out the lower housing, getting into the corners and the channel where the filter's rubber frame seals. Don't unplug it unless you need the slack, and never touch its sensing element.

6

Drop the new filter into the lower housing

On the 3.1L, an unseated filter lets dirty air bypass the media and foul the throttle body, so walk your finger around the perimeter to confirm nothing is rolled under.

7

Re-lid, re-clip, and re-clamp

Lower the air cleaner cover back onto the lower housing so it sits square — if it rocks, the filter is misaligned, so reseat it before forcing anything. Listen for whistling around the box and make sure the idle is smooth.

🔧 Mechanic's note — Tom Becker

I've fought enough rust to know: If a spring clip is rusted stiff, work it gently — forcing it snaps the clip, and a missing clip means the lid never seals again without a trip to the parts store.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Forgetting to re-tighten the outlet duct clamp, causing an intake air leak
  • • Leaving a spring clip half-latched so the lid rattles loose
  • • Forcing the lid over a misaligned filter instead of reseating it