EZCarFix DIY Auto Repair
← Back to Buick Century Guides

1997–2005 Buick Century

1997-2005 Buick Century — Engine Oil & Filter Change

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧 Moderate 30-60 minutes $57 DIY

Save $63 by doing it yourself! Shop cost: $120

Quick answer: Engine Oil & Filter Change on a 1997–2005 Buick Century is rated Moderate and takes about 30-60 minutes. You'll need 2 tools for this job, and parts cost about $57. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$57.00
Oil spec 3.1L V6
Capacity 4.5 qt with filter Viscosity 5W-30 (alt: 0W-30)
Part Name Part Number Price Buy
Engine Oil (5W-30) — $45.00
Correct engine oil filter and drain-plug washer for 1997-2005 Buick Century — $12.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm the Century's oil spec and raise the front

3.1L V6: 4.5 quarts 5W-30 with filter. Standard is the PF47 spin-on; the larger PF52 fits as an upgrade — direct thread-and-gasket match; verify subframe clearance. Gather drain pan and hand tools. Park level, brake set, chock wheels; raise front on ramps or stands.

🔧 Mechanic's note — Ray Delgado

The PF52 upgrade is free extra filtration — same threads, same gasket, just longer. I've run them on 3.1Ls for years; just confirm it clears the subframe before you fill.

2

Locate the filter and drain plug

Warm briefly, shut off. The spin-on filter is on the block's front — look from below, just behind the bumper line; the plug is on the pan bottom. Pan under the plug. Spot the filter from above with a flashlight.

3

Drain the oil and swap the filter

Pull the plug; drain fully — give it ten minutes. Unscrew the old filter (strap wrench helps in the tight space); wipe the boss. Oil the new gasket; hand-tight plus a quarter turn.

🔧 Mechanic's note — Ray Delgado

Oil near the filter that isn't the filter is almost always those lower intake gaskets on the 3.1L — I've seen the filter changed three times before someone looked up. If the block above the filter is wet, the gaskets are your leak.

4

Reinstall the plug and refill

Refit the plug with a fresh washer at manual torque. Lower to level; pour 4.5 quarts 5W-30. Wait a minute, dipstick. Over-full means the old oil didn't drain completely.

5

Check for leaks and verify the level

Run 30 seconds; check underneath for drips at plug and filter. Off, wait two minutes, recheck dipstick. Wipe spills; recycle oil and filter. Fitted the larger PF52? Recheck the level after your first drive.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Using the wrong viscosity, capacity, or filter
  • • Working under a vehicle supported only by a jack
  • • Reusing a crushed drain-plug washer or leaving the old filter gasket stuck
  • • Over-tightening the filter or drain plug
  • • Starting the engine without first verifying oil was added