EZCarFix DIY Auto Repair
← Back to Chevrolet Blazer Guides

2019–2024 Chevrolet Blazer

2019-2024 Chevrolet Blazer — Cabin Air Filter Replacement

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 5–10 minutes $28 DIY

Save $72 by doing it yourself! Shop cost: $100

Quick answer: Cabin Air Filter Replacement on a 2019–2024 Chevrolet Blazer is rated Easy and takes about 5–10 minutes. Parts cost about $28. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$28.00
Part Name Part Number Price Buy
Cabin air filter for 2019-2024 Chevrolet Blazer; verify arrows, size, and VIN/trim fitment — $28.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm fitment and locate the filter

The Chevrolet Blazer returned as a midsize crossover for 2019, and every 2019–2024 Blazer — whether the 2.5L four-cylinder, the 2.0L turbo, or the 3.6L V6 — keeps its cabin air filter behind the glove box.

2

Prep and switch the ignition off

Turn the ignition off and take the key or fob with you so the blower cannot switch on during the job. A flashlight aimed behind the dash will help you spot the tray clips once the box is down.

3

Detach the damper arm and lower the glove box

Open the glove box and look at its right outer edge for the damper arm. Unclip the arm from the side of the box so the box can swing freely.

4

Lift the old filter from the tray and note the arrow

Lift the old filter out of the tray and look at the airflow arrow printed on its frame — note which way it points (downward, toward the floor, on most Blazers) so the new one goes in the same way.

5

Clean the tray and housing

Wipe or vacuum the tray and the inside of the housing to remove dust and leaf bits that accumulated around the old filter. Keep debris out of the empty housing opening. Set the new filter into the tray.

6

Reinstall the tray and the glove box

Slide the tray back into the housing and push until its side tabs click and lock into place — give it a gentle tug to confirm it is latched. Open and close the box to verify it moves smoothly and latches shut.

7

Test the HVAC and plan the next change

Start the car and run the fan from low to high on fresh-air mode, checking the passenger vents for strong, steady airflow and listening for whistles that would mean the tray is not fully latched.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Pulling on the tray without squeezing its side tabs, which jams it in the housing
  • • Reinstalling the tray without confirming the tabs clicked, leaving a gap that lets dust bypass the filter
  • • Installing the new filter with the airflow arrow reversed
  • • Forgetting to reclip the damper arm so the glove box drops open hard