EZCarFix DIY Auto Repair
← Back to Chevrolet Blazer Guides

2019–2024 Chevrolet Blazer

2019-2024 Chevrolet Blazer — Brake Pad Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 14, 2026

🔧🔧🔧 Advanced 1-3 hours $205 DIY

Save $245 by doing it yourself! Shop cost: $450

Quick answer: Brake Pad Replacement on a 2019–2024 Chevrolet Blazer is rated Advanced and takes about 1-3 hours. You'll need 3 tools for this job, and parts cost about $205. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$205.00
Part Name Part Number Price Buy
Front or rear brake pad set for 2019-2024 Chevrolet Blazer; verify axle, brake package, and VIN fitment — $180.00
Replacement pad hardware or wear sensor only if the kit requires it — $25.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm axle, parts, and brake condition

FRONT axle, 2019–2024 Blazer (crossover, not the old S-10): floating dual-piston cast-iron calipers — two 47.6mm phenolic pistons — on vented rotors, with anti-rattle spring and stainless abutment clips. Confirm front-axle pads; Check rotor thickness against the hat minimum.

2

Lift and secure the vehicle

Level ground, parking brake set (it holds the rear), rear wheels chocked. Loosen the lugs, raise the front onto stands at the factory pinch-weld points. Wheel off; turn the steering toward the working side for better bolt access.

3

Remove the caliper and old pads

Remove the caliper guide-pin bolts and lift the dual-piston caliper off the bracket; hang it with a hook so the hose is never strained. Pull the old pads, the anti-rattle spring, and the abutment clips from the bracket.

4

Install the hardware

Clean the bracket lands to bare metal and install new abutment clips with high-temperature brake grease beneath them. Tackling one piston alone will push its twin back out.

🔧 Mechanic's note — Tom Becker

I've seen this go wrong too often: That twin-piston warning is real: compress one side and the other one walks out of its bore. A dual-piston spreader costs less than the mess you'll make without one.

5

Torque, pump, and bed in

Reinstall the caliper and torque the guide-pin bolts to the service-data spec. Pump the pedal until firm, recheck the reservoir, then bed the pads with moderate stops from about 40 mph in a safe area, avoiding hard stops for the first 150-200 miles.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Changing only one pad or mixing pad sets on an axle
  • • Working under a vehicle supported only by a jack
  • • Letting the caliper hang from the brake hose
  • • Forcing a seized piston or ignoring a leaking caliper
  • • Skipping final lug and caliper torque or the bedding procedure