EZCarFix DIY Auto Repair
← Back to Chevrolet Blazer Guides

2019–2024 Chevrolet Blazer

2019-2024 Chevrolet Blazer — Oil Change

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Nov 14, 2026

🔧🔧 Moderate 45 minutes $40 DIY 5 views

Save $70 by doing it yourself! Shop cost: $110

Quick answer: Oil Change on a 2019–2024 Chevrolet Blazer is rated Moderate and takes about 45 minutes. You'll need 7 tools for this job, and parts cost about $40. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$40.00
Part Name Part Number Price Buy
Engine Oil (5W-30 Full Synthetic) — $30.00
Oil Filter — $10.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Prepare (5W-30 Dexos1, 6.0 qt!)

The 2019–2024 Blazer (3.6L LGX V6) takes 5W-30 full synthetic Dexos1 Gen3, 6.0 quarts (5.7L) with filter — buy 7 quarts. You'll need: new filter (GM 19330000 or equivalent), drain pan, funnel. Park on level ground.

2

Drain the Old Oil

Position the drain pan under the drain plug and remove it, letting the old 5W-30 drain (expect ~6.0 quarts). The LGX is easy on oil, but keep to the Dexos1 Gen3 spec.

3

Replace Oil Filter

Remove the old oil filter. Install the new one (GM 19330000 or equivalent) — hand-tighten plus a quarter turn — and make sure the old gasket came off with the old filter.

4

Reinstall Drain Plug (18 ft-lbs)

Reinstall the drain plug and torque to 18 ft-lbs — use a torque wrench and don't over-tighten. The LGX's 18 ft-lbs is a light spec; stripping the threads is the expensive mistake.

🔧 Mechanic's note — Tom Becker

I've found that the single most expensive oil-change mistake on these LGX engines is a drain plug cranked down by feel. Eighteen foot-pounds is not much — buy the torque wrench, set it, and stop when it clicks.

5

Add 6.0 Quarts of 5W-30

Add 6.0 quarts (5.7L) of 5W-30 Dexos1 Gen3 full synthetic through the filler. Use ONLY Dexos1 Gen3-approved 5W-30 — not 0W-20, which is for the V8 trucks. Check the dipstick.

6

Check Level, Leaks, Reset Monitor

Start the engine and check for leaks, then recheck the oil level after 30 seconds and top up if needed. Reset the oil life monitor. Interval: follow the monitor, typically 7,500 miles.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Not allowing the engine to cool before draining oil
  • • Over-tightening the oil filter
  • • Using incorrect oil type or viscosity