EZCarFix DIY Auto Repair
← Back to Chevrolet Colorado ZR2 Guides

2017–2024 Chevrolet Colorado ZR2

2017-2024 Chevrolet Colorado ZR2 — Brake Pad Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 14, 2026

🔧🔧🔧 Advanced 1-3 hours $205 DIY

Save $245 by doing it yourself! Shop cost: $450

Quick answer: Brake Pad Replacement on a 2017–2024 Chevrolet Colorado ZR2 is rated Advanced and takes about 1-3 hours. You'll need 3 tools for this job, and parts cost about $205. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$205.00
Part Name Part Number Price Buy
Front or rear brake pad set for 2017-2024 Chevrolet Colorado ZR2; verify axle, brake package, and VIN fitment — $180.00
Replacement pad hardware or wear sensor only if the kit requires it — $25.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm axle, parts, and brake condition

FRONT axle of the Colorado ZR2 — dual-piston front caliper. Buy front pads plus abutment clips and silicone brake grease. Siphon the reservoir below MAX. Wash the bracket area and check slide pins move freely — ZR2 mud seizes pins.

🔧 Mechanic's note — Tom Becker

I've pulled ZR2 calipers packed solid with dried mud — the pins seize and taper-wear a new set of pads in weeks. I wash the bracket area out first and make sure both pins slide free before anything goes back together.

2

Lift and secure the vehicle

Park level, chock the rears, brake set. Break the front lug nuts loose on the ground, then jack the front at the factory points onto rated stands — never under a jack alone. Remove the wheel.

3

Remove the caliper and old pads

Remove the guide-pin bolts and slide the caliper off the rotor. Hang it with a hanger — never by the hose, and don't touch the pedal while it's off. Pull the pads and inspect rotor, pins, boots, and piston seal.

4

Install pads and hardware

Clean the bracket lands and snap in the new abutment clips. Compress both pistons evenly through the old pad so they stay square. Watch the reservoir level. Keep grease off the friction faces; wipe the rotor with brake cleaner.

🔧 Mechanic's note — Ray Delgado

I've seen one piston pushed and the other popped right out of its bore — on a dual-piston caliper you compress both together or you make a mess. I use a C-clamp through the old pad and keep them square.

5

Torque, pump, and bed in

Torque caliper and bracket bolts to GM spec. Refit the wheel, lower it, and tighten the lug nuts star-pattern. Pump the pedal until firm. Bed the pads with moderate stops; avoid hard stops for a couple hundred miles.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Changing only one pad or mixing pad sets on an axle
  • • Working under a vehicle supported only by a jack
  • • Letting the caliper hang from the brake hose
  • • Forcing a seized piston or ignoring a leaking caliper
  • • Skipping final lug and caliper torque or the bedding procedure