EZCarFix DIY Auto Repair
← Back to Chrysler Sebring Guides

2001–2006 Chrysler Sebring

2001-2006 Chrysler Sebring — Spark Plug Replacement

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧🔧 Advanced 1-3 hours $115 DIY

Save $335 by doing it yourself! Shop cost: $450

Quick answer: Spark Plug Replacement on a 2001–2006 Chrysler Sebring is rated Advanced and takes about 1-3 hours. You'll need 4 tools for this job, and parts cost about $115. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$115.00
Part Name Part Number Price Buy
Correct spark plug set for the gasoline/ICE engine in 2001-2006 Chrysler Sebring; verify engine, heat range, gap, and VIN fitment — $115.00
Coil-boot seals or ignition coils only if inspection finds damage Optional — $35.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm engine and plug fitment

The specified plug is Mopar 68303923AA, gapped to 0.050 in (1.3 mm). Buy six. The 2.4L four-cylinder Sebring uses a different 0.044 in gap — confirm your engine on the underhood sticker before ordering. Scan for misfire codes (P0301–P0306).

2

Cool and expose the plugs

Let the 2.7L cool completely. Remove the plastic engine cover and the air intake ducting. The front-bank coils are exposed on top of the valve cover; Disconnect the negative battery cable and label every connector and hose you disturb.

3

Inspect the coil boots

Inspect each coil boot for cracks, oil contamination, or carbon tracking; the 2.7L is known for valve-cover gasket leaks that soak the rear-bank boots in oil.

🔧 Mechanic's note — Tom Becker

I never trust my eyes alone here: If the rear-bank boots come out soaked in oil, don't just swap the plugs and move on — that's the valve-cover gasket leaking, and it'll keep fouling whatever you put in there.

4

Remove and install plugs

Use a 5/8 in spark plug socket on the Mopar 68303923AA plugs. Crack each plug loose and spin it out by hand. Verify the gap at 0.050 in with a wire gauge. Thread each new plug in by hand to protect the aluminum head threads, then tighten to the factory torque spec with a torque wrench — never use an impact. Do not apply anti-seize unless the plug manufacturer specifically calls for it on your plug.

5

Reconnect and verify

Reinstall the coils, tighten the 8 mm hold-down bolts, and click each connector back on. Road-test and re-scan; a returning P030x code points to the coil on that cylinder, especially oil-soaked rear-bank coils.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Using the wrong plug or assuming a pre-gapped plug needs no verification
  • • Blowing debris into an open cylinder or plug well
  • • Cross-threading a plug or tightening it without a torque wrench
  • • Overusing anti-seize or dielectric grease on the plug threads
  • • Mixing coil connectors or ignoring a misfire after reassembly