EZCarFix DIY Auto Repair
← Back to Chrysler Sebring Guides

2001–2006 Chrysler Sebring

2001-2006 Chrysler Sebring — Engine Air Filter Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 25-40 minutes $35 DIY

Save $75 by doing it yourself! Shop cost: $110

Quick answer: Engine Air Filter Replacement on a 2001–2006 Chrysler Sebring is rated Easy and takes about 25-40 minutes. You'll need 3 tools for this job, and parts cost about $35. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$35.00
Part Name Part Number Price Buy
Engine air filter for 2001-2006 Chrysler Sebring; verify engine, housing shape, and VIN fitment — $35.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Figure out which Sebring airbox you have

The sedan and convertible (Chrysler platform, 2.4L or 2.7L) use a cylindrical filter cartridge that plugs into the intake boot — that's the PITA procedure everyone warns about on forums. If your coupe has a clip-on lid, just pop the clips and swap the panel.

2

Locate the air cleaner housing and the inlet tube

On the 2.7L convertible there's barely any elbow room in there, so you may need to shift some wiring looms out of the way gently; the 2.4L sedan has a little more space.

3

Free the sensor and the vacuum hoses

Carefully pull the sensor out of the back of the inlet tube near the hose clamp end — owners report it slides out once you get the angle right, and you can leave its wiring connected while you work.

4

Loosen the band clamp at the throttle body

Follow the inlet tube to where it meets the throttle body and loosen the band clamp there with a flat-blade screwdriver or a 10mm socket.

5

Press the two tabs and pull the old filter out

Press them in while you carefully wiggle the boot — and the cylindrical filter plugged into it — out of the housing. The filter is a cylinder that seats inside the boot, not a panel, so don't try to pry it sideways.

🔧 Mechanic's note — Tom Becker

My rule: Those two boot tabs are the reason this job has a reputation — go slow and keep a finger on them as you wiggle, because they love to pop back out and snag a wire. Patience here saves you a harness repair.

6

Fit the new cylinder filter into the boot

Clean any grit out of the housing so it can't get into the clean side of the intake. Push it in square until it seats fully in the boot — a half-seated filter will rattle and can unseat the boot over time.

7

Reinstall the tube, bracket hardware, and clamp

Seat the boot past the tabs; set the housing on its bracket; run the 5/16-inch nut down — snug, not gorilla-tight. Refit the vacuum hose and tube to the throttle body; tighten the band clamp with its screw left reachable.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Forgetting to align the two arrows on the inlet-tube sensor when reinstalling it
  • • Crushing the rubber isolation mount by overtightening the 5/16-inch housing nut
  • • Letting the boot's release tabs snag and tear nearby wiring while maneuvering