Quick answer: Spark Plug Replacement on a 2006–2012 BMW M5 is rated Advanced and takes about 3–4 hours for the ten-plug S85 V10; about 2 hours for the eight-plug S63 V8. You'll need 7 tools for this job, and parts cost about $115. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name |
Part Number |
Price |
Buy |
| Correct spark plug set for the gasoline/ICE engine in 2006-2012 BMW M5; verify engine, heat range, gap, and VIN fitment |
— |
$115.00 |
|
| Coil-boot seals or ignition coils only if inspection finds damage Optional |
— |
$35.00 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm which M5 engine you have and let it cool fully
Park on level ground, set the parking brake, and let the engine cool completely; both engines have aluminum cylinder heads, and removing plugs from a hot head risks pulling the threads out with the plug.
2
Remove the engine covers and air filter housings
On the S85 V10, unclip and lift off the two large plastic engine covers, then remove both air filter housings — each bank's five ignition coils sit in deep plug tubes beneath them.
🔧 Mechanic's note — Ray Delgado
I don't reuse crush washers. They're one-time-use for a reason. For marine or small engines, I follow the specific guidance. They have unique requirements.
3
Disconnect and pull the rod-type ignition coils
Grip each coil and pull straight up out of its tube — they are a friction fit and can be stubborn, so a coil puller tool helps avoid tearing the rubber boot. Keep the coil connectors clean and never force them; on the S85 the plugs also serve as knock sensors.
4
Remove the old spark plugs
Using a 14mm thin-wall spark plug socket on a long extension — a standard socket will jam in these deep, narrow wells — loosen each plug and lift it out.
5
Check the gap on every new plug with a wire gauge
Never assume new plugs are gapped correctly out of the box. Check each plug's electrode gap against the specification in your owner's manual or the under-hood emissions sticker. If adjustment is needed, bend only the ground strap gently and re-check.
6
Hand-start each plug, then seat the washer
Never start a plug with a ratchet, or you risk cross-threading the soft aluminum head. Once finger-tight, snug each plug with the ratchet a quarter to a half turn further to crush the washer and seat the plug. Do not overtighten: repairing stripped plug threads in these heads is a major job.
7
Reinstall the coils, airboxes, and test the engine
Push each coil firmly back onto its plug until it is fully seated, reconnect every coil connector until the locking tab clicks shut, then reinstall the air filter housings and engine covers. Double-check that no tools, rags, or fasteners were left in the engine bay. Start the engine and let it idle — it should run smoothly with no misfire or check-engine light. Take a short test drive and listen for any stumble under load, which would point to a coil connector that is not fully latched.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Starting a plug with a ratchet and cross-threading the aluminum head
- • Buying six or eight plugs for the S85 V10 — it needs ten
- • Forgetting to reconnect a coil connector, causing a misfire on first start
- • Using a standard-wall socket that wedges in the deep plug wells