EZCarFix DIY Auto Repair
← Back to BMW M5 Guides

2006–2012 BMW M5

2006-2012 BMW M5 — Brake Pad Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 21, 2026

🔧🔧🔧 Advanced 1-3 hours $205 DIY

Save $245 by doing it yourself! Shop cost: $450

Quick answer: Brake Pad Replacement on a 2006–2012 BMW M5 is rated Advanced and takes about 1-3 hours. You'll need 5 tools for this job, and parts cost about $205. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$205.00
Part Name Part Number Price Buy
Front or rear brake pad set for 2006-2012 BMW M5; verify axle, brake package, and VIN fitment — $180.00
Replacement pad hardware or wear sensor only if the kit requires it — $25.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm axle, parts, and brake condition

FRONT axle only. M5: two-piston floating front calipers on large vented rotors. Buy front pads for your exact trim, new hardware, a fresh wear sensor. Reservoir near MAX? Siphon some out. Release the wear-sensor connector first.

🔧 Mechanic's note — Tom Becker

Release that wear-sensor connector before the caliper moves an inch. I've seen them yanked apart because somebody forgot the wire was tethered to the chassis.

2

Lift and secure the vehicle

Park level; chock the rear wheels; brake set. Break the lug nuts loose on the ground; jack the front at the factory points; settle onto rated stands — never under a jack alone. Remove the wheel.

3

Remove the caliper and old pads

Pry off the caps to expose the 6 mm hex bolts; remove both; slide the caliper off. Unclip the wear sensor. Hang the caliper with a hook. Pull the pads; inspect the rotor face, pins, boots, and piston dust seal.

4

Install pads and hardware

Fit the new wear sensor into the inner pad first — single-use once its wire loop wears through. Retract both pistons evenly on the old pads with a spreader; watch the reservoir. Keep grease off the friction faces and rotor.

5

Torque, pump, and bed in

Torque all caliper fasteners to the BMW spec for your model year. Refit the wheel; lower; tighten the lugs in a star pattern. Pump pedal until firm. Bed with moderate stops; avoid hard stops for the first couple hundred miles.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Changing only one pad or mixing pad sets on an axle
  • • Working under a vehicle supported only by a jack
  • • Letting the caliper hang from the brake hose
  • • Forcing a seized piston or ignoring a leaking caliper
  • • Skipping final lug and caliper torque or the bedding procedure