← Back to BMW M5 Guides

2019–2024 BMW M5

2019-2024 BMW M5 — Cabin Air Filter Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 25 minutes $28 DIY

Save $72 by doing it yourself! Shop cost: $100

Quick answer: Cabin Air Filter Replacement on a 2019–2024 BMW M5 is rated Easy and takes about 25 minutes. You'll need 1 tool for this job, and parts cost about $28. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$28.00
Part Name Part Number Price Buy
Cabin air filters (pair) for 2019-2024 BMW M5; verify arrows, size, and VIN/trim fitment — $28.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm the F90 setup and park the car

Covers the 2019–2024 BMW M5 (F90) — base, Competition, CS: two charcoal panel microfilters under the passenger-side footwell, beside the blower motor; no cowl filter under the hood. Budget 25 minutes. Park level, ignition off, key out of range.

2

Make room in the passenger footwell

Move the passenger seat all the way back and recline it slightly. Lay a towel across the door sill. Headlamp on — you'll be on your back, head in the footwell, looking up under the glove box.

3

Remove the footwell trim panel

Rotate the two thumb screws 90 degrees to release the panel. Pull the front edge down to free the rear guide hooks. Disconnect the footwell-light wiring plug and unclip its wire retainer. Leave the fuse box alone.

4

Remove the filter-housing lid

Undo the two Torx bolts (T15/T20) and pull the drain tube off the white filter-housing lid. Swap the filters WITHOUT releasing the lid's rear-left tabs — drop the lid on its front edge instead; those tabs are the hardest to reseat.

🔧 Mechanic's note — Ray Delgado

In my experience, Those rear-left tabs are the whole battle. If you can swap the filters without fully releasing them, do it — reseating them blind above the harness cover is the fiddliest part of this job.

5

Pull the old filters and photograph their orientation

Slide both filters down and out. They're airflow-specific and can sit mirrored, so photograph them seated in the housing first. Verify old and new pairs match in size and thickness. Vacuum the empty housing and check the foam sealing edges.

🔧 Mechanic's note — Ray Delgado

From my bay, Take that orientation photo before you touch anything — the pair sits mirrored and getting one backwards cuts your airflow and makes the system whistle.

6

Install the new pair and close the housing

Bow each new filter past the housing lip, matching your photo's orientation. Press each filter home and refit the drain tube. Engage the rear-left tabs FIRST, then swing the lid up and snug the two Torx bolts by feel — snug is tight enough.

7

Reinstall the trim and test every mode

Reconnect the footwell-light plug, engage the rear guide hooks, and swing the panel up until thumb screws lock. Test every mode: fan low to max, fresh air and recirculation, heat and A/C, dash and defrost — strong airflow, no whistling.

🔧 Mechanic's note — Ray Delgado

Take it from me: BMW calls for these roughly every 15,000 miles or once a year — sooner in dusty conditions. Set a calendar reminder so you don't forget; a clogged pair quietly kills your airflow.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Reversing one filter’s orientation so the pair no longer matches the original airflow direction
  • • Fighting the rear-left lid tabs above the harness cover instead of seating them first
  • • Forgetting to reconnect the footwell-light harness before the trim panel goes back
  • • Stripping the plastic lid threads by over-tightening the Torx bolts