Quick answer: Change Transmission Fluid on a 2019–2024 BMW M5 is rated Advanced and takes about 2-3 hours. You'll need 8 tools for this job, and parts cost about $355. This guide walks you through the full job step by step, including the mistakes to avoid.
| Part Name |
Part Number |
Price |
Buy |
| BMW Automatic Transmission Fluid (ATF) |
83222365904 |
$200.00 |
|
| Transmission Drain Plug Washer |
24117523588 |
$5.00 |
|
| Transmission Filter Kit |
24117523589 |
$150.00 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Confirm fluid type and procedure
On the 2019-2024 BMW M5 Competition: read the owner’s manual or service info for the exact transmission fluid specification (e.g., ATF+4, Toyota WS, Honda ATF DW-1, ZF Lifeguard, CVT-specific fluid). Use only the specified fluid — the wrong ATF/CVT fluid can damage the unit.
🔧 Mechanic's note — Ray Delgado
I read the service info for the exact fluid spec before buying — on an M5, I've learned 'close enough' ATF is the most expensive kind.
2
Warm up and safely raise the vehicle
Raise and support the 2019-2024 BMW M5 Competition on jack stands rated for the weight. Wear gloves and eye protection — transmission fluid can be hot.
3
Drain the old fluid
On the 2019-2024 BMW M5 Competition: place a drain pan under the transmission. Remove the drain plug (or carefully loosen the pan bolts in a crisscross pattern, leaving two corners snug until fluid slows). Allow fluid to drain fully.
🔧 Mechanic's note — Tom Becker
I leave two corners snug until the flow slows — I've dropped a trans pan full of fluid once, and the cleanup taught me patience.
4
Service the filter and pan if applicable
If this service includes a filter, remove the pan, clean the magnet and mating surfaces, and replace the filter and pan gasket (or RTV only if the maker specifies). Reinstall the pan and tighten the bolts to the specified torque in a crisscross pattern — don't overtighten and warp the pan.
5
Refill with the correct fluid
Lower the 2019-2024 BMW M5 Competition if needed for access. Fill through the fill plug on the side of the transmission case using a fluid pump — the ZF 8HP is a sealed unit with no dipstick tube, so a funnel from above will not work. Pump in the specified BMW-approved ZF 8HP ATF (e.g., ZF Lifeguard 8) until fluid starts to run out of the fill plug; the final level is set with the engine running at the specified fluid temperature in the next step. Do not use universal “any ATF” unless the label explicitly lists your spec.
6
Set level at the correct temperature
On the 2019-2024 BMW M5 Competition: start the engine, cycle through gears (Park→Reverse→Drive and back, pausing in each) with your foot on the brake, then check level per the manual — often idling in Park on level ground for dipstick units, or at a specified temperature with fluid just seeping from the check plug on sealed units. Add in small amounts; never overfill.
7
Inspect for leaks and test drive
On the 2019-2024 BMW M5 Competition: shut down briefly and inspect the pan, drain plug, and cooler lines for seepage. Take a short drive with gentle shifts, then recheck the level hot if required.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Not using the correct transmission fluid type
- • Overfilling or underfilling the transmission
- • Failing to properly torque the drain and fill plugs
- • Not allowing the transmission to reach operating temperature before checking fluid level
- • Ignoring the need to replace the drain plug washer