Quick answer: Oil and Filter Change on a 2017–2022 Buick Regal is rated Easy and takes about 30–45 minutes. You'll need 7 tools for this job, and parts cost about $44. This guide walks you through the full job step by step, including the mistakes to avoid.
Oil spec
2.0L turbo I4 (FWD)
Capacity 5.0 qt with filter Viscosity 5W-30 (alt: 0W-30) Spec dexos1
| Part Name |
Part Number |
Price |
Buy |
| 5W-30 dexos-approved engine oil (5 quarts) |
— |
$30.00 |
|
| Spin-on oil filter |
— |
$14.00 |
|
| Drain plug gasket (if equipped) Optional |
— |
$5.00 |
|
About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.
💡 Pro tip: Order all parts at once to save on shipping
Step-by-Step Instructions
Follow these steps carefully
1
Warm the engine and prepare the vehicle
Run the Regal's 2.0L turbo engine for 2–3 minutes so the oil flows freely, then park on level ground and set the parking brake. Gather 5 quarts of dexos-approved 5W-30, a new filter, and a drain pan before you start. Pop the hood and remove the engine cover if it blocks the oil fill cap.
2
Access the drain plug from underneath
The Regal sits low, so you may need ramps or a jack with stands to reach the oil pan — never crawl under a car held only by a jack. Locate the drain plug on the bottom of the oil pan toward the rear. Position a wide drain pan underneath, offset slightly toward the rear since the oil shoots out initially.
🔧 Mechanic's note — Ray Delgado
Don't learn this the expensive way like I did: the Regal sits low, so I use ramps or stands — I've never crawled under a car on just a jack.
3
Drain the old oil
Remove the oil fill cap on the valve cover to vent the crankcase for faster draining. Loosen the drain plug with a wrench, then unscrew it by hand, keeping pressure inward until the threads release so oil does not run down your arm. Allow at least 10 minutes for a complete drain until only occasional drips fall.
4
Replace the spin-on oil filter
Find the spin-on filter on the front side of the engine block near the oil pan. Loosen it with a filter wrench and spin it off by hand, tipping it upright immediately to contain the oil inside. Clean the mounting boss with a rag, verify the old gasket is not stuck to it, then oil the new filter's gasket and install hand-tight plus three-quarter turn.
5
Reinstall the drain plug and add new oil
Thread the drain plug back in by hand to prevent cross-threading, then snug it with a wrench — the aluminum pan strips easily, so do not overtighten. Pour 5 quarts of 5W-30 dexos oil through the fill tube using a funnel. Reinstall the fill cap and the engine cover.
🔧 Mechanic's note — Tom Becker
Quick word from someone who's been under there: I thread the plug in by hand — the Regal's aluminum pan strips easily, so I never overtighten.
6
Check the level and inspect for leaks
Start the engine and let it run for 30 seconds to fill the new filter, then shut it off and wait 2 minutes. Check the dipstick. Look under the car at the drain plug and filter for drips while the engine idles.
7
Reset the oil-life monitor
Use the steering-wheel controls to navigate to the oil-life display in the driver information center. Hold the checkmark button until it prompts to reset, then confirm — the display should read 100%.
8
Recycle the used oil and filter
Funnel the used oil into sealed containers and bag the old filter to prevent drips. Note the mileage and date; the 2.0L turbo typically calls for changes every 7,500 miles or when the monitor indicates.
All Done!
Test your repair before closing everything up. If something doesn't work right, double-check your steps.
⚠️ Common Mistakes to Avoid
- • Using non-dexos oil, which the 2.0L turbo's variable valve timing requires for proper operation.
- • Overtightening the filter or drain plug, making the next change difficult or damaging the pan.
- • Forgetting to reset the oil-life monitor, so the reminder stays on.