EZCarFix DIY Auto Repair
← Back to Buick Regal Guides

2011–2016 Buick Regal

2011-2016 Buick Regal — Battery Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 30-90 minutes $180 DIY

Save $120 by doing it yourself! Shop cost: $300

Quick answer: Battery Replacement on a 2011–2016 Buick Regal is rated Easy and takes about 30-90 minutes. You'll need 2 tools for this job, and parts cost about $180. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$180.00
Part Name Part Number Price Buy
Replacement 12-volt battery for 2011-2016 Buick Regal; verify group size, CCA, terminal layout, and VIN fitment — $180.00
Anti-corrosion terminal protectant or felt washers (optional) Optional — $8.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm the Regal battery specs and its covered location

Regal: BCI Group 48 (H6), about 615 CCA, tucked under a junction block/cover on most trims — the cover comes off before the terminals are visible. AGM recommended; flooded works as a budget option. Positive terminal on the top right.

🔧 Mechanic's note — Ray Delgado

In my experience, That junction block cover hides the terminals completely, so don't buy a battery sight-unseen online — match the Group 48 size and positive-on-top-right layout to your old one in person.

2

Park, make it safe, and save your settings

Park level, brake set, ignition off, key out. Safety glasses and gloves on. A memory saver preserves presets and avoids theft-deterrent headaches — without one, have the radio code handy. 10 mm for terminals, socket set, wire brush, terminal protector.

3

Move the junction block cover and disconnect, negative first

Lift the junction block/cover off the battery. Loosen the negative (black) clamp, twist it off the post, and tuck the cable aside. Then loosen the positive (red) clamp and lift it free. Keep the wrench off adjacent metal.

4

Unbolt the hold-down and install the new battery

Remove the hold-down and lift the old Group 48 out — about 47 lbs. Wire-brush the platform and both clamps with baking-soda solution and dry. Set the new Group 48 in, positive post top right, and reinstall the hold-down.

5

Reassemble, reconnect, and verify the charging system

Reseat the junction block/cover as it was. Reconnect positive first, then negative. Start up and confirm a brisk crank. Run the battery-sensor reset if the manual calls for it. Reset the clock and presets, check running voltage (13.5-14.5 volts), and recycle the old battery.

🔧 Mechanic's note — Ray Delgado

From my bay, The battery-sensor reset is the step everyone skips, and then the charging system throws warnings for a week. If your manual mentions it, do it before the test drive.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Buying by appearance instead of group size, CCA, polarity, and hold-down fit
  • • Shorting the positive terminal to the body with a metal tool
  • • Lifting the battery by damaged terminals or leaving it unsecured
  • • Skipping battery registration, window/clock resets, or charging-system checks when required
  • • Assuming a new battery fixes a parasitic draw or charging fault