EZCarFix DIY Auto Repair
← Back to Dodge Intrepid Guides

1993–1997 Dodge Intrepid

1993-1997 Dodge Intrepid — Spark Plug Replacement

By Tom Becker ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧🔧🔧 Advanced 1-3 hours $115 DIY

Save $335 by doing it yourself! Shop cost: $450

Quick answer: Spark Plug Replacement on a 1993–1997 Dodge Intrepid is rated Advanced and takes about 1-3 hours. You'll need 4 tools for this job, and parts cost about $115. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$115.00
Part Name Part Number Price Buy
Correct spark plug set for the gasoline/ICE engine in 1993-1997 Dodge Intrepid; verify engine, heat range, gap, and VIN fitment — $115.00
Coil-boot seals or ignition coils only if inspection finds damage Optional — $35.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm engine and plug fitment

Scan for misfire codes (P0300-P0306) first and check the plug wires too — on a car this age, brittle wires cause more misses than the plugs themselves.

2

Cool and expose the plugs

Remove the air intake ducting for working room, and on the 3.5L consider removing the upper intake plenum if the rear bank defeats you — new plenum gaskets are cheap insurance.

3

Remove the wires

Disconnect the other ends from the coil pack one at a time, labeling as you go; crossed wires on a waste-spark V6 will run but misfire under load.

4

Install the new plugs

Thread each plug in by hand for several turns until it seats on its gasket, then torque to the spec in your service manual (the classic figure for 14mm gasket-seat plugs is 18-22 ft-lb; confirm for your engine).

5

Reconnect and verify

Route each new or reused plug wire to its correct cylinder — double-check against the firing order cast into the intake or your manual, because a crossed pair is the classic self-inflicted wound on this job.

🔧 Mechanic's note — Tom Becker

When a P030x survives fresh plugs and correct routing, the new plugs are innocent — check that cylinder's coil tower or injector next. I've seen people re-gap a perfect set of plugs three times chasing a dead coil tower.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Using the wrong plug or assuming a pre-gapped plug needs no verification
  • • Blowing debris into an open cylinder or plug well
  • • Cross-threading a plug or tightening it without a torque wrench
  • • Overusing anti-seize or dielectric grease on the plug threads
  • • Mixing coil connectors or ignoring a misfire after reassembly