EZCarFix DIY Auto Repair
← Back to Audi S4 Guides

2010–2024 Audi S4

2010-2024 Audi S4 — Brake Pad Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 14, 2026

🔧🔧🔧 Advanced 1-3 hours $205 DIY

Save $245 by doing it yourself! Shop cost: $450

Quick answer: Brake Pad Replacement on a 2010–2024 Audi S4 is rated Advanced and takes about 1-3 hours. You'll need 3 tools for this job, and parts cost about $205. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$205.00
Part Name Part Number Price Buy
Front or rear brake pad set for 2010-2024 Audi S4; verify axle, brake package, and VIN fitment — $180.00
Replacement pad hardware or wear sensor only if the kit requires it — $25.00

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm the front brake setup

B8 and B9 use single-piston floating front calipers. The inner pad snaps into the piston by its prongs; the outer pad sits on the carrier. Order a wear sensor with the pads — the old one rarely survives removal.

2

Lift and secure the S4

Park level, chock the rears, brake set. Break the lug bolts loose on the ground — Audis use bolts, so leave one loosely threaded while you jack. Raise the front on stands and remove the wheel.

3

Remove the caliper and old pads

Remove the caliper bolts and slide the caliper off the rotor. Hang it with a hook — never by the hose. Unplug the wear sensor without pulling the wire. Pull inner pad from piston first, then outer pad off carrier.

🔧 Mechanic's note — Tom Becker

I've seen the inner pad installed backwards on these — the prongs snap into the piston, not the carrier. I always double-check the prongs are seated in the piston before the caliper goes back on.

4

Prep the hardware and retract the piston

Wire-brush the carrier's slide surfaces; apply grease or anti-squeal paste to the pad backs. Inspect pins and boots. Push the piston back with a C-clamp and the old pad, slow and even. Check the reservoir first; siphon if near MAX.

5

Install pads, torque, and pump

Snap the inner pad into the piston and set the outer pad on the carrier. Reinstall caliper bolts and torque to spec; reconnect the wear sensor. Refit the wheel and torque the lug bolts star-pattern to spec. Pump until firm.

🔧 Mechanic's note — Ray Delgado

I've bedded S4 pads the lazy way and paid for it with squeal for weeks — the firm stops from 60 to 20 mph without a full stop, then a long cool-down cruise, actually matter on these cars. I don't skip it.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Changing only one pad or mixing pad sets on an axle
  • • Working under a vehicle supported only by a jack
  • • Letting the caliper hang from the brake hose
  • • Forcing a seized piston or ignoring a leaking caliper
  • • Skipping final lug and caliper torque or the bedding procedure