EZCarFix DIY Auto Repair
← Back to Chevrolet Spark Guides

2016–2022 Chevrolet Spark

2016-2022 Chevrolet Spark — Brake Pad Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 14, 2026

🔧🔧 Moderate 90-150 minutes $55 DIY

Save $265 by doing it yourself! Shop cost: $320

Quick answer: Brake Pad Replacement on a 2016–2022 Chevrolet Spark is rated Moderate and takes about 90-150 minutes. You'll need 3 tools for this job, and parts cost about $55. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost
$55.00
Part Name Part Number Price Buy
Vehicle-specific front brake pad set — $55.00
Brake pad hardware / shim kit — —

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

1

Confirm axle, parts, and brake condition

Match pads to the M400 Spark fitment with the shim set. Measure rotor thickness with a micrometer against the hat-stamped minimum. Look up caliper and bracket torque values in GM service information; the small caliper bolts strip easily if over-torqued.

🔧 Mechanic's note — Ray Delgado

I've measured plenty of Spark rotors that were already under minimum thickness by the second pad change — the rotors are thin, so don't skip the micrometer or you'll be doing the job twice.

2

Lift and secure the vehicle

Set the parking brake, break lug nuts loose on the ground, and lift one front corner onto a stand under the pinch weld — never work under the jack alone. Chock the rear wheels. Check the reservoir level; pushing the piston back raises it.

3

Remove the caliper and old pads

Unbolt the caliper, slide it off the rotor, and hang it from the strut — never by the hose. Slide the pads out, noting the wear-indicator position. Pull and clean the slide pins, and check the pin boots, piston boot, and brake hose.

🔧 Mechanic's note — Tom Becker

In the salt belt I've freed more seized slide pins on these little calipers than I can count — if a pin won't move by hand after cleaning, work it out gently and re-grease with silicone grease before it snaps.

4

Install pads and hardware

Clean the bracket and fit new clips. Set the pads in — wear indicator in its original spot, shims in place. Compress the piston with a C-clamp. Re-grease pins with silicone brake grease, slide the caliper over the pads, and keep grease off friction surfaces.

5

Torque, pump, and bed in

Torque caliper and bracket hardware to GM values with a torque wrench — never guess. Refit the wheel; torque lug nuts in star pattern. Pump the pedal until firm, bed the pads with stops from about 35 mph, and recheck lug nuts after 50 miles.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

  • • Installing pads without inspecting rotor thickness, runout, or condition
  • • Hanging a caliper by its hose or damaging the hose
  • • Failing to lubricate only the correct pad contact points
  • • Driving before pumping the pedal and completing a careful bedding check