2007–2011 Toyota Camry

2007-2011 Toyota Camry — Wiper Blade Replacement

By Ray Delgado ✓ Certified Mechanic · Published Sep 21, 2026 · Updated Oct 22, 2026

🔧 Easy 15 minutes $66 DIY 1 views

Save $4 by doing it yourself! Shop cost: $70

Quick answer: Wiper Blade Replacement on a 2007–2011 Toyota Camry is rated Easy and takes about 15 minutes. You'll need 1 tool for this job, and parts cost about $66. This guide walks you through the full job step by step, including the mistakes to avoid.

Quick Video Tutorial

Parts You Need

Total Cost

$65.98

Part Name	Part Number	Price	Buy
Driver wiper blade, 24"	Bosch 24A	$32.99	Amazon
Passenger wiper blade, 20"	Bosch 20B	$32.99	Amazon

About prices: shown prices are typical retail averages and change frequently; cheaper alternatives may be available. Confirm the current price before buying.

💡 Pro tip: Order all parts at once to save on shipping

Step-by-Step Instructions

Follow these steps carefully

Service position (if needed)

The 2007-2011 Toyota Camry (XV40) needs no special service position — the arms lift straight off the glass by hand where they park.

Lift the wiper arm

Raise one Camry wiper arm until it stays up and lay a folded towel on the windshield beneath it. Never let a bare spring-loaded arm snap onto the glass — the spring tension is enough to chip it.

🔧 Mechanic's note — Ray Delgado

I lay the towel down before lifting the arm — I've seen a bare Camry arm snap back and chip the glass, and the repair dwarfed the blade cost.

Release the old blade

The Camry uses J-hook arms: press the release tab where the blade meets the hook and slide the blade down out of the hook. Pull in line with the arm rather than twisting sideways, which can bend the arm.

Match the new blade

The 2007-2011 Camry takes a 24-inch driver-side blade and a 20-inch passenger-side blade on J-hook arms — the same sizes across all these model years and trims.

Install until it clicks

Thread the new blade's connector into the J-hook until it clicks, then tug gently to confirm it is locked. The 24-inch blade goes on the driver side, the 20-inch on the passenger side.

🔧 Mechanic's note — Tom Becker

I tug after the click and double-check the sizes — 24-inch driver, 20-inch passenger, and I've seen them swapped more than once.

Lower and repeat

Lower the arm gently onto the windshield and repeat on the other side. Top off the washer fluid, mist the glass, and run a full wipe cycle. The sweep should be smooth and streak-free.

🔧 Mechanic's note — Ray Delgado

I mist the glass and run a full wipe cycle — a dry test wipe can chatter, and I've learned the wet test is the honest one.

All Done!

Test your repair before closing everything up. If something doesn't work right, double-check your steps.

⚠️ Common Mistakes to Avoid

• Forgetting to replace both wiper blades simultaneously, leading to uneven wiping performance.
• Installing the wrong size wiper blades, resulting in inadequate coverage.
• Not securely attaching the new wiper blades, causing them to detach during operation.

Tools You'll Need

None

⚠️ Safety First!

• Ensure the wiper arm is securely held away from the windshield to prevent accidental snapping back.
• Avoid placing hands near the wiper blade's attachment point during installation to prevent pinching injuries.
• Do not operate the wipers while the vehicle is stationary to prevent unnecessary wear on the wiper components.